FRONT WIPER MOTOR REMOVAL

PROCEDURE


  1. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    1. A01QCQF

      Remove the nut and front wiper arm and blade assembly LH.

  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    1. A01QCX4

      Remove the nut and front wiper arm and blade assembly RH.

  3. REMOVE ENGINE ROOM SIDE COVER LH


    1. A01Q9QF

      Remove the 2 clips.

    2. Disengage the guide to remove the engine room side cover LH.

  4. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    1. A01QAVG

      Disengage the claws to remove the 2 windshield outside mouldings.

    2. Remove the 2 clips.

      A01QA2LC01
      B002C8N Remove in this Direction - -

    3. Disengage the claws and guides as shown in the illustration.

    4. Disengage the guides to remove the cowl top ventilator louver sub-assembly as shown in the illustration.

      A01QCUNC01
      B002C8N Remove in this Direction - -

  5. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    1. w/ Windshield Deicer System:


      1. A01QAO3

        Disconnect the connector.

    2. A01QB1A

      Disconnect the connector.

    3. Remove the 2 bolts.

    4. A01Q9Y1

      Disengage the motor grommet as shown in the illustration to remove the windshield wiper motor and link assembly.

      Note

      Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.

  6. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    1. A01QBEWC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, separate the No. 1 windshield wiper link rod from the pivot of the windshield wiper motor assembly as shown in the illustration.

    2. A01Q96C

      Using a T30 "TORX" socket wrench, remove the 2 bolts and windshield wiper motor assembly from the windshield wiper link assembly.