OUTER REAR VIEW MIRROR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for both the LH and RH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


    1. B002E2N

      Engage the claws and guides to temporarily install the outer rear view mirror assembly.

    2. Install the outer rear view mirror assembly with the 3 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Engage the clamps.

    4. Connect the connector.

  2. INSTALL NO. 2 FRONT DOOR SERVICE HOLE COVER


    1. Remove the peeling paper from a new No. 2 front door service hole cover.

    2. A01XPWFC01
      *a Reference Point

      Install the No. 2 front door service hole cover according to the reference points on the front door panel.

      Note

      Securely install the No. 2 front door service hole cover preventing wrinkles and air bubbles.

  3. INSTALL OUTER MIRROR PROTECTOR


    1. B002EPOC01
      *a Reference Point

      Remove the peeling paper from a new outer mirror protector.

    2. Install the outer mirror protector according to the reference points on the front door panel.

  4. INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

    Click here

  5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  6. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  7. INSTALL FRONT ARMREST BASE UPPER PANEL

    Click here

  8. INSTALL FRONT DOOR HOLE COVER

    Click here

  9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here