LUGGAGE COMPARTMENT DOOR OPENER MAIN SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the glove compartment door assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effects/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Parking assist monitorsystem	Click here
		LKA/LDA system	Click here
		Pre-crash safety system
		Adaptive high beam system
	Reset power trunk lid	Power trunk lid system	Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

Tech Tips

Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the LHD vehicles.

PROCEDURE

PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click here

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable theSRS system.

Click here

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE INSTRUMENT CENTER CLUSTER FINISH PANEL SUB-ASSEMBLY

Click here
REMOVE INSTRUMENT SIDE PANEL RH

Click here
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here
REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Click here
REMOVE LUGGAGE DOOR OPENING CANCEL SWITCH ASSEMBLY
1. Disengage the claws to remove the luggage door opening cancel switch assembly.