SLIDING ROOF HOUSING REASSEMBLY

PROCEDURE


  1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    1. Engage the guides as shown in the illustration to install the roof wind deflector panel sub-assembly.

      A01Q9FGC01
      B002C8N Install in this Direction (1) B002E01 Install in this Direction (2)

    2. Engage the 2 springs as shown in the illustration to install the roof wind deflector panel sub-assembly.

      A01Q8XZC03
      *1 Spring - -
      B002C8N Install in this Direction - -

      Note

      Make sure that the springs are securely installed.

  2. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    1. A01Q8QV

      Hold down the roof wind deflector panel sub-assembly.

    2. Using a screwdriver with its tip wrapped in protective tape, slide the 2 sliding roof drive cable sub-assemblies in the directions indicated by the arrows shown in the illustration to install them.

      A01Q8QQC01
      *a Protective Tape - -
      B002C8N Install in this Direction - -

  3. INSTALL REAR ROOF DRIP CHANNEL


    1. Engage the claws and slide the rear roof drip channel frontward to install it.

      A01QC31

  4. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    1. A01Q9VTC01
      B002C8N Install in this Direction

      Install the sunshade trim sub-assembly as shown in the illustration.

    2. A01QBD2

      Engage the guide to install the sliding roof piece LH.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. Install the screw.

  5. ADJUST FULLY CLOSED POSITION


    1. Slide the sliding roof drive cable LH in either direction and align the alignment marks as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

      A01Q8MRC02
      *a Alignment Mark - -

  6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. Apply MP grease to the gear of the sliding roof drive gear sub-assembly.

    2. A01Q92A

      Install the sliding roof drive gear sub-assembly with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    3. A01QAV2

      Engage the guides to install the map light bracket.

    4. Engage the claw.

  7. TEMPORARILY INSTALL FRONT SLIDING ROOF HOUSING MOUNTING BRACKET LH


    1. A01QAE5

      Temporarily install the front sliding roof housing mounting bracket with the bolt.

  8. TEMPORARILY INSTALL FRONT SLIDING ROOF HOUSING MOUNTING BRACKET RH

    Tech Tips

    Use the same procedure as for the LH side.