POWER WINDOW REGULATOR MOTOR(for Rear Side) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

   
   

   1. Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.

   2. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

   Click here

3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

4. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

5. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

   Click here

6. INSTALL REAR DOOR GLASS RUN

   Click here

7. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

8. INSTALL REAR NO. 2 SPEAKER ASSEMBLY

   Click here

9. INSTALL REAR DOOR ARMREST SET BRACKET

   Click here

10. INSTALL REAR DOOR GLASS INNER WEATHERSTRIP

    Click here

11. INSTALL REAR DOOR FRAME GARNISH

    Click here

12. INSTALL REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

    Click here

13. INSTALL REAR DOOR TRIM COVER

    Click here

14. INSTALL REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

15. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

16. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR ARMREST BASE UPPER PANEL

    Click here

17. INSTALL REAR DOOR HOLE COVER

    Click here

18. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

20. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

21. CHECK POWER WINDOW

    Click here