POWER WINDOW REGULATOR MOTOR(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power window regulator motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Power window regulator motor assembly Rear door window regulator sub-assembly Rear door glass sub-assembly Rear door glass run	Initialize power window control system	Auto up and down function Jam protection function Catch protection function Remote control function Wireless transmitter-linked function Key-off operation function Window open warning function	Click here
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Parking assist monitor system	Click here
		LKA/LDA system	Click here
		Pre-crash safety system
		Adaptive high beam system
	Reset power trunk lid	Power trunk lid system	Click here

Tech Tips

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click here
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

Click here
REMOVE REAR DOOR HOLE COVER

Click here
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR ARMREST BASE UPPER PANEL

Click here
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Click here
REMOVE REAR DOOR NO. 1 STIFFENER CUSHION

Click here
REMOVE REAR DOOR TRIM COVER

Click here
REMOVE REAR DOOR GLASS INNER WEATHERSTRIP

Click here
REMOVE REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

Click here
REMOVE REAR DOOR FRAME GARNISH

Click here
REMOVE REAR DOOR ARMREST SET BRACKET

Click here
REMOVE REAR NO. 2 SPEAKER ASSEMBLY

Click here
REMOVE REAR DOOR SERVICE HOLE COVER

Click here
REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

Click here
REMOVE REAR DOOR GLASS RUN

Click here
REMOVE REAR DOOR QUARTER WINDOW GLASS

Click here
REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Click here
REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

Click here
REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
1. Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.