POWER WINDOW REGULATOR MOTOR(for Front Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.

    2. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

    Click here

  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  4. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  5. INSTALL FRONT DOOR ARMREST SET BRACKET

    Click here

  6. INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

    Click here

  7. INSTALL DOOR FRAME GARNISH

    Click here

  8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  10. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL

    Click here

  11. INSTALL FRONT DOOR HOLE COVER

    Click here

  12. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

  14. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  15. CHECK POWER WINDOW

    Click here