POWER WINDOW REGULATOR MOTOR(for Front Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power window regulator motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

  • Power window regulator motor assembly

  • Front door window regulator sub-assembly

  • Front door glass sub-assembly

 Initialize power window control system

  • Auto up and down function

  • Jam protection function

  • Catch protection function

  • Remote control function

  • Key-linked function

  • Wireless transmitter-linked function

  • Key-off operation function

  • Window open warning function

Click here

Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  4. REMOVE FRONT DOOR HOLE COVER

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL

    Click here

  6. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  8. REMOVE DOOR FRAME GARNISH

    Click here

  9. REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

    Click here

  10. REMOVE FRONT DOOR ARMREST SET BRACKET

    Click here

  11. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  12. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  13. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

    Click here

  14. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. B002C5A

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.