REAR POWER WINDOW SWITCH INSPECTION

PROCEDURE


  1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    1. A01QAEEC09
      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly)

      Check the switch function.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        2 (UP) - 5 (GND) Manual UP operation Below 1 Ω
        10 (DOWN) - 5 (GND) Manual DOWN operation Below 1 Ω

        2 (UP) - 5 (GND)

        4 (AUTO) - 5 (GND)

        		 AUTO UP operation Below 1 Ω

        10 (DOWN) - 5 (GND)

        4 (AUTO) - 5 (GND)

        		 AUTO DOWN operation Below 1 Ω

        If the result is not as specified, replace the rear power window regulator switch assembly.

    2. A01QAEEC10
      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly)

      Check that the LED illuminates.


      1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 8 (LED)

        Battery negative (-) → 5 (GND)

        		 LED illuminates

        If the result is not as specified, replace the rear power window regulator switch assembly.