REAR SUNSHADE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear sunshade assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE REAR SEAT ASSEMBLY

    Click here

  2. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  3. REMOVE REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  5. REMOVE REAR SEAT SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  6. REMOVE ROOF SIDE INNER GARNISH LH

    Click here

  7. REMOVE ROOF SIDE INNER GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  8. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER

    Click here

  9. REMOVE CENTER CHILD RESTRAINT SEAT TETHER ANCHOR COVER (w/ Center Bracket)

    Click here

  10. REMOVE REAR SEAT SHOULDER BELT HOLE COVER

    Click here

  11. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  12. REMOVE CENTER STOP LIGHT COVER

    Click here

  13. REMOVE NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY


    1. B002DLEC02
      B002C8N Remove in this Direction (1)
      B002E01 Remove in this Direction (2)

      Disengage the clips and guides to remove the No. 2 package tray trim panel assembly as shown in the illustration.

  14. REMOVE REAR WINDOW SHADE ASSEMBLY


    1. B002DZ3

      Disconnect the connector.

    2. Remove the 4 bolts and rear window shade assembly.