ROOM PARTITION PANEL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the room partition panel removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE REAR SEAT ASSEMBLY

    Click here

  2. SEPARATE NO. 1 ROOM PARTITION PAD


    1. B002EL1C01
      B002DP3 Roll up

      Roll up the No. 1 room partition pad as shown in the illustration.

  3. REMOVE ROOM PARTITION PANEL SUB-ASSEMBLY

    CAUTION:


    • Wear protective gloves when performing this work.

    • Performing this work without wearing protective gloves could result in injury.

    B002DNO

    1. B002DNQ

      Remove the 6 bolts.

    2. Remove the 2 nuts and room partition panel sub-assembly.