ROOF HEADLINING DISASSEMBLY

PROCEDURE


  1. REMOVE NO. 1 ROOF WIRE (w/ Sliding Roof)


    1. B002F0ZC01
      *A w/ Rain Sensor for LHD
      *B w/ Rain Sensor for RHD
      *C w/ LKA/LDA system
      *D w/o LKA/LDA system
      *E w/ Camera Heater

      Disengage the guides to disconnect the wire harness connectors.

    2. Peel off the 15 pieces of adhesive tape.

      B002EICC01
      *a Clamp *b Guide
      B002CL1 Adhesive Tape - -

    3. Disengage the clamps.

    4. Disengage the guide.

    5. B002CGNC01
      B002DP3 Turn

      Turn the visor connector approximately 90° counterclockwise and disconnect the visor connectors as shown in the illustration.

      Tech Tips

      Use the same procedures for the opposite side.

    6. Remove the No. 1 roof wire from the roof headlining.

  2. REMOVE NO. 1 ROOF WIRE (w/o Sliding Roof)


    1. B002F0ZC01
      *A w/ Rain Sensor for LHD
      *B w/ Rain Sensor for RHD
      *C w/ LKA/LDA system
      *D w/o LKA/LDA system
      *E w/ Camera Heater

      Disengage the guides to disconnect the wire harness connectors.

    2. Peel off the 16 pieces of adhesive tape and remove the No. 1 roof wire.

      B002DR7C01
      B002CL1 Adhesive Tape - -

    3. Disengage the clamps.

    4. B002CGNC01
      B002DP3 Turn

      Turn the visor connector approximately 90° counterclockwise and disconnect the visor connectors as shown in the illustration.

      Tech Tips

      Use the same procedures for the opposite side.

    5. Remove the No. 1 roof wire from the roof headlining.