ROOF HEADLINING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the roof headlining removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

Spiral cable with sensor sub-assembly

  • Steering angle neutral point (Initialize parking assist monitor system)

  • Steering angle setting

 Parking assist monitor system

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. REMOVE REAR SEAT ASSEMBLY

    Click here

  4. REMOVE INSTRUMENT PANEL SAFETY PAD

    Click here

  5. REMOVE REAR DOOR SCUFF PLATE LH


    1. B002CTZC01
      B002D0A Place Hands Here
      B002C8N Remove in this Direction

      Disengage the claws and clips to remove the rear door scuff plate LH as shown in the illustration.

  6. REMOVE REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LH side.

  7. REMOVE CENTER PILLAR LOWER GARNISH LH


    1. B002EH4C01
      B002D0A Place Hands Here
      B002C8N Remove in this Direction

      Disengage the claws and clips to remove the center pillar lower garnish LH as shown in the illustration.

  8. REMOVE CENTER PILLAR LOWER GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  9. REMOVE CENTER PILLAR UPPER GARNISH LH


    1. B002DZQC01
      B002D0A Place Hands Here
      B002C8N Remove in this Direction

      Remove the 2 screws.

    2. Disengage the clip to remove the center pillar upper garnish LH as shown in the illustration.

  10. REMOVE CENTER PILLAR UPPER GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  11. REMOVE REAR SEAT SIDE GARNISH LH


    1. B002CSPC01
      B002D0AC03 Place Hands Here
      B002C8N Remove in this Direction

      Disengage the claws and guide to remove the rear seat side garnish LH as shown in the illustration.

  12. REMOVE REAR SEAT SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  13. REMOVE ROOF SIDE INNER GARNISH LH (w/ Rear Sunshade)


    1. B002CAUC01
      B002D0A Place Hands Here
      B002C8N Remove in this Direction (1)
      B002E01 Remove in this Direction (2)

      Disengage the clips and guides to remove the roof side inner garnish LH as shown in the illustration.

  14. REMOVE ROOF SIDE INNER GARNISH RH (w/ Rear Sunshade)

    Tech Tips

    Use the same procedure as for the LH side.

  15. REMOVE ROOF SIDE INNER GARNISH LH (w/o Rear Sunshade)


    1. B002EN8C01
      B002D0A Place Hands Here
      B002C8N Remove in this Direction (1)
      B002E01 Remove in this Direction (2)

      Disengage the clips and guides to remove the roof side inner garnish LH as shown in the illustration.

  16. REMOVE ROOF SIDE INNER GARNISH RH (w/o Rear Sunshade)

    Tech Tips

    Use the same procedure as for the LH side.

  17. REMOVE NO. 2 FORWARD RECOGNITION COVER (w/ Lane Departure Alert System)

    Click here

  18. REMOVE NO. 1 FORWARD RECOGNITION COVER (w/ Lane Departure Alert System)

    Click here

  19. REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER (w/o Lane Departure Alert System)

    Click here

  20. REMOVE RAIN SENSOR COVER (w/ Rain Sensor)

    Click here

  21. REMOVE SPOT LIGHT ASSEMBLY

    Click here

  22. REMOVE MAP LIGHT ASSEMBLY

    Click here

  23. REMOVE VANITY LIGHT ASSEMBLY

    Click here

  24. REMOVE VISOR BRACKET COVER

    Click here

  25. REMOVE VISOR ASSEMBLY LH

    Click here

  26. REMOVE VISOR ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  27. REMOVE VISOR HOLDER

    Tech Tips

    Use the same procedures for the opposite side.


    1. B002EVAC01
      B002DP3 Turn in this Direction
      B002C8N Remove in this Direction

      Turn the holder clockwise approximately 45° and pull it out as shown in the illustration.

    2. B002DCGC01
      B002C8N Remove in this Direction

      Disengage the claws to remove the base as shown in the illustration.

  28. REMOVE ASSIST GRIP COVER

    Tech Tips

    Using the same procedure, remove every assist grip cover.


    1. B002DORC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, disengage the claws to remove the assist grip cover.

  29. REMOVE ASSIST GRIP SUB-ASSEMBLY

    Tech Tips

    Use the same procedures for the opposite side.


    1. B002E7SC01
      B002C8N Remove in this Direction

      Disengage the clips to remove the assist grip sub-assembly as shown in the illustration.

    2. Remove the 2 clips from the vehicle body.

  30. REMOVE REAR ASSIST GRIP ASSEMBLY LH


    1. B002CRNC01
      B002C8N Remove in this Direction

      Disengage the clips to remove the assist grip assembly LH as shown in the illustration.

    2. Remove the 2 clips from the vehicle body.

  31. REMOVE REAR ASSIST GRIP ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  32. REMOVE ROOF HEADLINING


    1. B002ER5

      for Front Pillar LH Side:


      1. Disconnect the connector.

      2. Using a clip remover, disengage the clamps.

    2. B002EIG

      for Front Pillar RH Side:


      1. Disconnect the connector.

      2. Using a clip remover, disengage the clamps.

    3. B002ELN

      w/ Rain Sensor:


      1. Disconnect the connector.

    4. B002EVF

      w/ Lane Departure Alert System:


      1. Disconnect the 2 connectors.

    5. B002DM1

      w/o Lane Departure Alert System:


      1. Disconnect the connector.

    6. w/ Camera Heater:


      1. B002F1P

        Disconnect the connector.

    7. B002EGJ

      w/ Sliding Roof:


      1. Disconnect the connector.

      2. Disengage the clips and hook-and-loop fasteners to remove the roof headlining.

        B002CMI

    8. w/o Sliding Roof:


      1. Disengage the clips and hook-and-loop fasteners to remove the roof headlining.

        B002DCQ
    9. B002ER7C01
      B002C8N Remove in this Direction

      Turn the roof headlining diagonally and bend slightly to remove it from the front passenger side door.

      Note


      • Make sure that wrinkles do not form in the roof headlining during removal.

      • Make sure that the roof headlining does not get caught on anything as it may become bent or damaged.

      • Do not damage the roof headlining or vehicle interior.