REAR SUNSHADE SYSTEM Only Front Switch Cannot Operate Rear Sunshade

DESCRIPTION

The rear window shade assembly receives the rear sun shade switch assembly signals and drives its built-in motor.

WIRING DIAGRAM

B002C8IE03

CAUTION / NOTICE / HINT

Note


  • Do not remove the ground bolt of the rear window shade assembly.

  • When the rear sun shade relay is replaced with a new one, do not use the wire harness packaged together with the new rear sun shade relay.

PROCEDURE


  1. INSPECT REAR SUN SHADE SWITCH ASSEMBLY


    1. Remove the rear sun shade switch assembly.

      Click here

    2. Inspect the rear sun shade switch assembly.

      Click here

      Result
      Proceed to
      OK
      NG

    NG

    REPLACE REAR SUN SHADE SWITCH ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (REAR SUN SHADE SWITCH ASSEMBLY- REAR WINDOW SHADE ASSEMBLY AND BODY GROUND)


    1. Disconnect the K47 rear sun shade switch assembly connector.

    2. Disconnect the U25 rear window shade assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K47-4 (E) - Body ground Always Below 1 Ω
      K47-3 (ECU) - U25-4 (SW) Always Below 1 Ω
      K47-3 (ECU) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK REAR WINDOW SHADE ASSEMBLY


    1. B002CA1C14
      *a

      Component without harness connected

      (Rear Window Shade Assembly)
      *b

      Component without harness connected

      (Rear Sun Shade Relay)

      Disconnect the rear window shade assembly connector.

    2. Disconnect the rear sun shade relay connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      U25-4 (SW) - A-4 (SW) Always Below 1 Ω
      U25-4 (SW) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK REAR SUN SHADE RELAY


    1. B002D5PC12
      *a

      Component with harness connected

      (Rear Sun Shade Relay)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      B-2 (MR) - B-1 (ME) Rear sun shade switch assembly pushed (rear sunshade lowers from fully raised position) 11 to 14 V
      B-1 (ME) - B-2 (MR) Rear sun shade switch assembly pushed (rear sunshade raises from fully lowered position) 11 to 14 V
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE REAR WINDOW SHADE ASSEMBLY Click here

    NG

    REPLACE REAR SUN SHADE RELAY Click here