AIR CONDITIONING PANEL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during theair conditioning control assembly (radio receiver assenbly) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Correct the steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

Radio receiver assembly Parking assist monitor system initialization Parking assist monitor system

Click here

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

      Click here

    • After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary (w/ SDARS System).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE INSTRUMENT CENTER CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  4. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (RADIO RECEIVER ASSEMBLY)


    1. B002DCV

      Remove the 2 screws.

    2. B002DW0C01
      B002C8N Remove in this Direction

      Pull in the direction indicated by the arrows in the illustration, disengage the claws and clips.

    3. Disconnect the connectors and remove the air conditioning control assembly (radio receiver assenbly).

  5. REMOVE NO. 1 RADIO BRACKET


    1. B002CRY

      Remove the 3 screws and No. 1 radio bracket.

  6. REMOVE NO. 2 RADIO BRACKET


    1. B002ELV

      Remove the 3 screws and No. 2 radio bracket.