OCCUPANT DETECTION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the occupant detection sensor (front seat cushion pad with cover RH) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Parking assist monitor system	Click here
		LKA/LDA system	Click here
		Pre-crash safety system
		Adaptive high beam system
	Reset power trunk lid	Power trunk lid system	Click here

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY RH

Tech Tips

Use the same procedure as for the driver side.

Click here
REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD RH

Tech Tips

Use the same procedure as for the driver side.

Click here
REMOVE FRONT SEAT CUSHION SHIELD RH

Tech Tips

Use the same procedure as for the driver side.

Click here
REMOVE FRONT INNER SEAT CUSHION SHIELD RH

Tech Tips

Use the same procedure as for the driver side.

Click here
DISCONNECT FRONT SEATBACK PAD WITH COVER RH

Tech Tips

Use the same procedure as for the driver side.

Click here
REMOVE OCCUPANT DETECTION SENSOR (FRONT SEAT CUSHION PAD WITH COVER RH)
1. Disconnect the connector.
2. Disengage the claw to separate the connector.
3. Disconnect the strap of the occupant detection sensor (front seat cushion pad with cover RH).
4. Disengage the hooks to remove the occupant detection sensor (front seat cushion pad with cover RH).