SEAT HEATER CONTROL(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the seat heater control sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE BENCH TYPE REAR SEATBACK ASSEMBLY

    Click here

  2. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY

    Tech Tips

    Use the same procedures as for the opposite side.


    1. B002CPT

      Disconnect the connector.

    2. B002DICC01
      B002C8N Remove in this direction

      Disengage the claw to remove the seat heater control sub-assembly as shown in the illustration.