FRONT SEAT CUSHION HEATER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat cushion heater (front seat cushion pad with cover) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

B002EOY

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the driver and front passenger side.

  • The procedure listed below is for the driver side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD

    Click here

  3. REMOVE FRONT SEAT CUSHION SHIELD

    Click here

  4. REMOVE FRONT INNER SEAT CUSHION SHIELD

    Click here

  5. DISCONNECT FRONT SEATBACK PAD WITH COVER

    Click here

  6. REMOVE FRONT SEAT CUSHION HEATER (FRONT SEAT CUSHION PAD WITH COVER)


    1. for Front Passenger Side:


      1. B002ELR

        Disconnect the connector.

      2. B002CDX

        Disengage the claw to separate the occupant detection sensor connector.

    2. B002ESP

      Disconnect the strap of the front seat cushion heater (front seat cushion pad with cover).

    3. Disengage the hooks to remove the front seat cushion heater (front seat cushion pad with cover).