REAR SEATBACK HEATER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear seatback heater (bench type rear seatback cover) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE BENCH TYPE REAR SEATBACK ASSEMBLY

    Click here

  2. REMOVE REAR SEAT CENTER ARMREST ASSEMBLY

    Click here

  3. REMOVE REAR SEAT WIRE

    Click here

  4. REMOVE REAR SEAT SHOULDER BELT GUIDE LH

    Click here

  5. REMOVE REAR SEAT SHOULDER BELT GUIDE RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. REMOVE REAR SEAT CENTER SHOULDER BELT GUIDE

    Click here

  7. REMOVE REAR SEAT HEADREST SUPPORT

    Click here

  8. REMOVE REAR SEATBACK HEATER (BENCH TYPE REAR SEATBACK COVER)


    1. Remove the 36 hog rings.

      B002DWY

    2. Pass the rear seatback pad through the holes in the rear seatback heater (bench type rear seatback cover) to separate the rear seatback heater (bench type rear seatback cover) as shown in the illustration.

    3. B002DJ1

      Pass the rear seatback heater wire harnesses through the holes in the rear seatback heater (bench type rear seatback cover) as shown in the illustration.

    4. Remove the rear seat airbag assembly LH.

      Click here

    5. Remove the rear seat airbag assembly RH.

      Tech Tips

      Use the same procedure described for the LH side.

    6. B002DPJ

      Pass the brackets of the rear seatback heater (bench type rear seatback cover) through the holes in the rear seatback pad as shown in the illustration.

    7. Remove the 36 hog rings and rear seatback heater (bench type rear seatback cover) from the rear seatback pad.

      B002DMF