FRONT SEAT INNER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat inner assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)


    1. B002CRK

      Disconnect the 2 connectors.

    2. Disengage the claw and clamps.

    3. B002DWP

      Disengage the clamp.

    4. Remove the nut and front seat inner belt assembly LH.

    5. Remove the front seat belt anchor plate.

  3. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)


    1. B002C9R

      Disconnect the connector.

    2. Disengage the claw and clamps.

    3. B002E12

      Disengage the clamp.

    4. Remove the nut and front seat inner belt assembly RH.

    5. Remove the front seat belt anchor plate.