POWER SEAT SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the position control ECU and switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Position control ECU and switch assembly Initialize position control ECU Front Power Seat Control System

Click here

Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

B002EOY

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the driver and front passenger side.

  • The procedure listed below is for the driver side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD

    Click here

  3. REMOVE RECLINING POWER SEAT SWITCH KNOB

    Click here

  4. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

    Click here

  5. REMOVE FRONT SEAT CUSHION SHIELD

    Click here

  6. REMOVE POSITION CONTROL ECU AND SWITCH ASSEMBLY


    1. B002C7Z

      Remove the 3 screws.

    2. B002CW5

      Disengage the guides to remove the position control ECU and switch assembly.