LUMBAR SUPPORT ADJUSTER ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lumbar support adjuster assembly LH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

B002EOY

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEATBACK PAD WITH COVER

    Click here

  2. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    1. B002EJ0

      Disengage the claw and guides to remove the front seatback edge protector.

      Note

      Use the same procedures as for the opposite side.

    2. B002DWEC01
      *a Guide
      *b Hook
      B002C8N Remove in this direction (1)
      B002E01 Remove in this direction (2)

      Pull in the direction indicated by the arrows (1) in the illustration to disengage the guides.

    3. Pull in the direction indicated by the arrows (2) in the illustration and disengage the hooks to remove the lumbar support adjuster assembly LH.