REAR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AIRBAG SENSOR


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • B002DW2

        Wait at least 90 seconds after disconnecting the cable from negative (-) battery terminal to disable the SRS system.

      • B002DNL

        If this procedure is performed without disconnecting the cable from negative (-) battery terminal, the airbag may deploy even if an impact is applied only to the rear airbag sensor. Therefore, make sure that the cable from negative (-) battery terminal is disconnected before performing this procedure.

    3. B002E8T

      Insert the pin (stopper) into the body hole to install the rear airbag sensor to the vehicle with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

    4. Connect the connector to the rear airbag sensor.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. While holding the outer housing, be sure to engage the connector until they are locked and check that the outer housing is in its original position (when locking, make sure that a click sound can be heard).

        B002CMWC27
        *a Outer Housing - -

    5. Check that there is no looseness in the installation parts of the rear airbag sensor.

  2. INSTALL REAR SEAT SIDE GARNISH

    Click here

  3. INSTALL REAR DOOR SCUFF PLATE

    Click here

  4. INSTALL REAR SEAT ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. INSPECT SRS WARNING LIGHT

    Click here