CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • B002DW2

        Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

    3. Clean any remaining adhesive from the bolt holes for the curtain shield airbag assembly in the vehicle body.

    4. Engage the claws and hooks.

      Note

      Do not twist the curtain shield airbag assembly when installing it.

      B002D62C01
      *1 Clip *a Pin

    5. Install 4 new bolts.

      Torque:
      10.8 N*m  { 110 kgf*cm, 8 ft.*lbf }

    6. Install new clips and then push in new pins to each clip.

    7. B002D9FC01
      *a Connector Lock

      Connect the curtain shield airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    8. Push in the connector lock to install the airbag connector.

  2. INSTALL ROOF HEADLINING

    Click here

  3. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  4. INSPECT SRS WARNING LIGHT

    Click here