KNEE AIRBAG ASSEMBLY(for Front Passenger Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lower No. 2 instrument panel airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Correct the steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    B002C8O

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    CAUTION:


    • B002DW2

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

  3. REMOVE INSTRUMENT CENTER CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  4. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  6. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  7. DISCONNECT GLOVE COMPARTMENT DOOR STOPPER SUB-ASSEMBLY


    1. B002CRO

      Remove the 4 screws and disconnect the 2 glove compartment door stopper sub-assemblies from the glove compartment door assembly.

  8. REMOVE NO. 2 GLOVE COMPARTMENT PLATE


    1. B002EU2C01
      B002C8N Remove in this Direction

      Disengage the claws and clip to remove the No. 2 glove compartment plate as shown in the illustration.

  9. REMOVE GLOVE COMPARTMENT PANEL


    1. B002ENAC01
      B002C8N Remove in this Direction

      Disengage the claws and clips and glove compartment panel as shown in the illustration.

  10. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    CAUTION:

    When storing the lower No. 2 instrument panel airbag assembly, keep the airbag deployment side facing upward.


    1. B002DIEC01
      *a Harness Clamp
      *b Hook

      Disengage the harness clamp to disconnect the airbag harness from the glove compartment door assembly.

    2. Remove the 4 bolts.

    3. Slightly bend the wall of the glove compartment door, disengage the hooks to remove the lower No. 2 instrument panel airbag assembly.