STEERING PAD INSTALLATION

PROCEDURE


  1. INSTALL HORN BUTTON ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


      • If the airbag deploys for any reason, it may cause a serious accident.

      B002DW2
    3. B002DJ5C01
      *a Connector Lock
      *b Horn Connector

      Connect the 2 airbag connectors to the horn button assembly.

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to only connect the connectors to each corresponding color.

    4. Push in the 2 locks to install the 2 airbag connectors.

    5. Connect the horn connector to the horn button assembly.

    6. B002DBQ

      Push the horn button assembly to engage the pins carefully.

      Note


      • Make sure that the pins are securely inserted into the steering holes.

      • Make sure to engage the 2 upper pins first.

      • Make sure that the horn button assembly is securely installed.

  2. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. Engage the guide and claw to install the lower No. 3 steering wheel cover.

  3. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. Engage the guide and claw to install the lower No. 2 steering wheel cover.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. INSPECT HORN BUTTON ASSEMBLY


    1. Make sure that the horn sounds.

      Tech Tips

      If the horn does not sound, inspect the horn system.

      Click here

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. INSPECT SRS WARNING LIGHT

    Click here