REAR SEAT SIDE AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear seat airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Correct the steering angle neutral point	Parking assist monitor system	Click here
		LKA/LDA system	Click here
		Pre-crash safety system
		Adaptive high beam system
	Reset power trunk lid	Power trunk lid system	Click here

Tech Tips

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

PROCEDURE

PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
REMOVE REAR SEAT ASSEMBLY

Click here
REMOVE REAR SEAT AIRBAG ASSEMBLY
CAUTION:
- *a Deployment Side
  
  When storing the rear seat side airbag assembly, keep the airbag deployment side facing upward.
- If the airbag deploys for any reason, it may cause a serious accident.
1. Remove the 6 hog rings and fold back the part of the bench type rear seatback cover.
2. Remove the nut.
3. Disengage the clamp.
4. Remove the 2 nuts and rear seatback plate together with the rear seat airbag assembly.
5. Disengage the clamp.
6. Remove the 2 nuts and rear seat airbag assembly from the rear seatback plate.
  
  Note
  
  The nuts must not be reused.