INNER REAR VIEW MIRROR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the inner rear view mirror removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effects/Inoperative when not Performed Link
Inner rear view mirror assembly

Re-registration of codes in the garage door opener system


  • Register transmitter code

  • Rolling code systems

 Garage door opener system

Click here

PROCEDURE


  1. REMOVE NO. 2 FORWARD RECOGNITION COVER (w/ Lane Departure Alert System)

    Click here

  2. REMOVE NO. 1 FORWARD RECOGNITION COVER (w/ Lane Departure Alert System)

    Click here

  3. REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER (w/o Lane Departure Alert System)


    1. B002E6PC01
      B002C8N Remove in this Direction

      Disengage the claws and guides to remove the inner rear view mirror stay holder cover as shown in the illustration.

  4. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/ Lane Departure Alert System)


    1. B002DLU

      Disconnect the connector.

    2. Using a clip remover, disengage the clamp to disconnect the wire harness.

    3. Using a T20 "TORX" socket wrench, remove the screw.

    4. B002EGSC01
      B002C8N Remove in this Direction

      Remove the inner rear view mirror assembly as shown in the illustration.

  5. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/o Lane Departure Alert System)


    1. B002EQKC01
      B002C8N Remove in this Direction

      Disconnect the connector.

    2. Using a T20 "TORX" socket wrench, remove the screw.

    3. Remove the inner rear view mirror assembly as shown in the illustration.