HEADUP DISPLAY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headup display removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  2. REMOVE HEADUP DISPLAY


    1. B002F06

      Remove the 4 screws.

    2. Disengage the guides to remove the headup display.

  3. REMOVE NO. 5 INSTRUMENT PANEL WIRE


    1. B002CTV

      Disconnect the connector to remove the No. 5 instrument panel wire.

  4. REMOVE NO. 1 COMBINATION METER MIRROR BRACKET (for LH Side)

    B002DW4

    1. Remove the 2 screws and No. 1 combination meter mirror bracket.

  5. REMOVE NO. 1 COMBINATION METER MIRROR BRACKET (for RH Side)


    1. B002COM

      Remove the 2 screws and No. 1 combination meter mirror bracket.