INTRUSION SENSOR CANCEL SWITCH INSPECTION

PROCEDURE


  1. INSPECT INTRUSION SENSOR CANCEL SWITCH (MAP LIGHT ASSEMBLY)


    1. A01QD8YC01
      *a

      Component without harness connected

      (Intrusion Sensor Cancel Switch (Map Light Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      13 (SOFF) - 10 (GND) Intrusion sensor cancel switch is pressed Below 1 Ω
      13 (SOFF) - 10 (GND) Intrusion sensor cancel switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the intrusion Sensor Cancel Switch (Map Light Assembly).