CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the LHD vehicles.
Use the same procedures for both the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
REMOVE REAR DOOR HOLE COVER
REMOVE REAR ARMREST BASE UPPER PANEL SUB-ASSEMBLY
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
REMOVE NO. 1 REAR DOOR STIFFENER CUSHION
REMOVE REAR DOOR TRIM COVER
REMOVE REAR DOOR GLASS INNER WEATHERSTRIP
REMOVE REAR SIDE CURTAIN ASSEMBLY (w/ Rear Sunshade)
REMOVE REAR DOOR FRAME GARNISH
REMOVE REAR DOOR ARMREST SET BRACKET
REMOVE REAR NO. 2 SPEAKER ASSEMBLY
REMOVE REAR DOOR SERVICE HOLE COVER
REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY
REMOVE REAR DOOR QUARTER WINDOW GLASS
REMOVE REAR DOOR GLASS SUB-ASSEMBLY
REMOVE REAR DOOR GLASS RUN
REMOVE REAR DOOR LOCK ASSEMBLY
Disconnect the connector.
| *1 | Release Plate |
|
Remove in this Direction |
Using a T30 "TORX" socket wrench, remove the 3 screws.
Disconnect the release plate to remove the rear door lock assembly as shown in the illustration.
When reusing the rear door lock assembly:
Remove the door lock wiring harness seal from the rear door lock assembly.
REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
| *A | w/o Double Locking System |
| *B | w/ Double Locking System |
|
Remove in this Direction |
Disengage the claw to open the cover as shown in the illustration.
| *A | w/o Double Locking System |
| *B | w/ Double Locking System |
Disengage the guide to remove the rear door lock remote control cable assembly.
REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
| *A | w/o Double Locking System |
| *B | w/ Double Locking System |
|
Remove in this Direction |
Disengage the claw to open the cover as shown in the illustration.
| *A | w/o Double Locking System |
| *B | w/ Double Locking System |
Disengage the guide to remove the rear door inside locking cable assembly.