FRONT DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicles.

  • Use the same procedures for both the LH and RH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY


    1. B002DBYC01
      *A w/o Double Locking System
      *B w/ Double Locking System

      Engage the guide to install the front door inside locking cable.

    2. B002C5BC01
      *A w/o Double Locking System
      *B w/ Double Locking System
      B002C8N Install in this Direction

      Engage the claws to close the cover as shown in the illustration.

  2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY


    1. B002E3VC01
      *A w/o Double Locking System
      *B w/ Double Locking System

      Engage the guide to install the front door lock remote control cable assembly.

  3. INSTALL FRONT DOOR LOCK ASSEMBLY

    Tech Tips


    • When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the front door lock assembly.


    1. Apply MP grease to the sliding parts of the front door lock assembly.

    2. When reusing the front door lock assembly:


      1. Install a new door lock wiring harness seal to the front door lock assembly.

    3. B002DDMC01
      *1 Front Door Lock Open Rod
      B002C8N Install in this Direction

      Connect the front door lock open rod as shown in the illustration.

      Tech Tips

      Make sure that the front door lock open rod is securely connected to the front door lock assembly.

    4. Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    5. Connect the connector.

  4. INSTALL FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)

    Click here

  5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  6. INSTALL FRONT DOOR GLASS RUN

    Click here

  7. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  8. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  9. INSTALL FRONT DOOR ARMREST SET BRACKET

    Click here

  10. INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

    Click here

  11. INSTALL DOOR FRAME GARNISH

    Click here

  12. INSTALL FRONT DOOR TRIM COVER

    Click here

  13. INSTALL NO. 1 FRONT DOOR STIFFENER CUSHION

    Click here

  14. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  15. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  16. INSTALL FRONT ARMREST BASE UPPER PANEL

    Click here

  17. INSTALL FRONT DOOR HOLE COVER

    Click here

  18. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here