DOOR CONTROL SWITCH INSPECTION

PROCEDURE


  1. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Driver Side)


    1. A01QC7QC07
      *a

      Component without harness connected

      (Multiplex Network Master Switch Assembly)

      Check that the LED illuminates.


      1. Apply battery voltage to the power window regulator master switch assembly and check that the LED illuminates.

        OK:
        Measurement Condition Specified Condition

        Battery positive (+) → 3 (ILL+)

        Battery negative (-) → 13 (ILL-)

        		 LED illuminates

        If the result is not as specified, replace the power window regulator master switch assembly.

  2. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Front Passenger Side)


    1. Check the resistance.


      1. A01QCNZC01
        *a

        Component without harness connected

        (Power Window Regulator Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        7 (UL) - 5 (GND) Unlock Below 1 Ω
        7 (UL) - 5 (GND) 12 (L) - 5 (GND) Off 10 kΩ or higher
        12 (L) - 5 (GND) Lock Below 1 Ω

        If the result is not as specified, replace the power window regulator switch assembly.

    2. A01QCNZC02
      *a

      Component without harness connected

      (Power Window Regulator Switch Assembly)

      Check that the LED illuminates.


      1. Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.

        OK:
        Measurement Condition Specified Condition

        Battery positive (+) → 1 (ILL+)

        Battery negative (-) → 6 (ILL-)

        		 LED illuminates

        If the result is not as specified, replace the power window regulator switch assembly.