GENERATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the generator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FAN AND GENERATOR V BELT

    Click here

  4. REMOVE GENERATOR ASSEMBLY


    1. B002DK7

      Disengage the clamp.

    2. Remove the bolt and disconnect the engine wire.

    3. B002F12C01
      *1 Terminal Cap
      *2 Oil Cooler Tube

      Open the terminal cap.

    4. Remove the nut and disconnect the engine wire from terminal B.

    5. Disconnect the generator assembly connector.

    6. Remove the bolt and separate the oil cooler tube.

    7. B002EGOC03
      *1 Engine Wire Bracket

      Remove the bolt A and engine wire bracket.

    8. Remove the bolt B and 2 nuts.

    9. B002DLG

      Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator assembly.