BLIND SPOT MONITOR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Removal/installation of blind spot monitor sensor Blind spot monitor beam axis adjustment DTCs are output

Click here

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE BLIND SPOT MONITOR SENSOR LH


    1. A01XQ0Y

      Disconnect the connector.

    2. Remove the 3 nuts and blind spot monitor sensor LH.

      Note

      Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.

  3. REMOVE BLIND SPOT MONITOR SENSOR RH

    Tech Tips

    Use the same procedure as for the LH side.