ULTRASONIC SENSOR(for Front Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 1 ultrasonic sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Removal/installation of front bumper assembly Adjust millimeter wave radar sensor assembly

  • Dynamic radar cruise control system

  • Pre-crash safety system

  • Forward recognition camera system

  • Lane departure alert system (w/ Steering Control)

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE NO. 1 ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure for both sides.


    1. B002EMG

      Disconnect the connector.

    2. B002DLD

      Disengage the claws to remove the No. 1 ultrasonic sensor.

  3. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Perform this step only when necessary.

    • Use the same procedure for both sides.


    1. Using an infrared light, warm the No. 1 ultrasonic sensor retainer.

      CAUTION:


      • Do not touch the infrared light or the heated portions of the components.

      • Touching the infrared light could result in burns.

      • Touching the heated portions of the components and remaining in contact for a long time could result in burns.

      B002CTYC28
      *a Heated Portions
      *b Infrared Light
      Heating Temperature
      Item Temperature
      No. 1 Ultrasonic Sensor Retainer

      40 to 60°C (104 to 140°F)

      3 to 5 minutes
    2. B002DHF

      Remove the No. 1 ultrasonic sensor retainer.