REAR CROSSING TRAFFIC ALERT BUZZER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear seat inner with center belt assembly LH and blind spot monitor buzzer removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  2. REMOVE BLIND SPOT MONITOR BUZZER


    1. B002CQ0

      Disconnect the connector.

    2. Disengage the clamp to remove the blind spot monitor buzzer.