TELEPHONE ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the telephone and GPS antenna (roof antenna assembly) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Correct the steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE ROOF HEADLINING

    Click here

  2. REMOVE TELEPHONE AND GPS ANTENNA (ROOF ANTENNA ASSEMBLY)


    1. B002F02

      Remove the bolt.

    2. B002D1T

      Remove the washer and holder as shown in the illustration.

    3. B002DIZ

      Remove the telephone and GPS antenna (roof antenna assembly) as shown in the illustration.

    4. B002C81C01
      B002C8N Remove in this Direction

      Disengage the claws and guides to remove the telephone and GPS antenna (roof antenna assembly) as shown in the illustration.

    5. B002EXE

      When reusing the telephone and GPS antenna (roof antenna assembly):


      1. Remove the seal.