TELEMATICS TRANSCEIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When replacing the multi-media module receiver assembly or telematics transceiver, perform the vehicle contract setting Click here.

    • The safety connect device uses the telematics transceiver to provide access to the network service.

    • The telematics transceiver has a DCM ID (described on the label attached to the telematics transceiver).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    Click here

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  5. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  6. REMOVE FRONT DOOR OPENING TRIM COVER RH

    Click here

  7. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  9. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  10. REMOVE TELEMATICS TRANSCEIVER


    1. B002F0R

      Remove the 3 bolts and telematics transceiver.

    2. Disconnect each connector.