NAVIGATION ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the navigation antenna assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Correct the steering angle neutral point Parking assist monitor system

Click here

LKA / LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  2. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

    Click here

  3. REMOVE NO. 3 HEATER TO REGISTER DUCT

    Click here

  4. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT (for RHD)

    Click here

  5. REMOVE NO. 1 HEATER TO REGISTER DUCT (for RHD)

    Click here

  6. REMOVE DEFROSTER NOZZLE ASSEMBLY (for RHD)

    Click here

  7. REMOVE NAVIGATION ANTENNA ASSEMBLY (for LHD)


    1. Disengage the clamps.

      B002D49

    2. Remove the 2 screws and the navigation antenna assembly.

  8. REMOVE NAVIGATION ANTENNA ASSEMBLY (for RHD)


    1. Disengage the clamps.

      B002DUK

    2. Remove the 2 screws and the navigation antenna assembly.