ASC SPEAKER(for Rear) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 2 speaker assembly with box removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Correct the steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  2. REMOVE NO. 2 SPEAKER ASSEMBLY WITH BOX


    1. B002DXO

      Disconnect the connector.

    2. Remove the 2 bolts.

    3. Disengage the clip to remove the No. 2 speaker assembly with box.