DIGITAL AUDIO BROADCASTING ANTENNA INSTALLATION

PROCEDURE


  1. INSTALL NO. 2 AMPLIFIER ANTENNA ASSEMBLY


    1. Use non-residue solvent to clean the area on the glass where the antenna will be installed.

      Note

      Do not use non-residue solvent to clean the antenna's contact points. Doing so may cause improper contact between the antenna and glass.

    2. Install the No. 2 amplifier antenna assembly with the 2 nuts.

      B002E43
      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

      Note


      • Just before installing the antenna to the glass, remove the protective cover of the antenna's contact points.

      • When removing the protective cover of the antenna's contact points, make sure the cover does not touch the contact points.

      • Never touch the contact points after removing the protective cover.

    3. Engage the clamps.

    4. Connect the connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here