INSTRUMENT PANEL SPEAKER INSTALLATION

PROCEDURE

1. INSTALL FRONT NO. 3 SPEAKER ASSEMBLY

   
   

   1. 

      Connect the connector.

   2. Install the front No. 3 speaker assembly with the 2 screws.

      Note

      
      

      • Do not touch the cone of the speaker.

      • When installing the front No. 3 speaker assembly, make sure that the wire harness does not get caught between the front No. 3 speaker assembly and instrument panel.

      Tech Tips

      Tighten the screws in the order shown in the illustration.

2. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY

   Click here

3. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY

   
   

   1. Connect the connector.

   2. Install the front No. 2 speaker assembly with the 2 screws.

      

      *A

      w/o Mark Levinson Speaker System

      *B

      w/ Mark Levinson Speaker System

      Note

      
      

      • Do not touch the cone of the speaker.

      • When installing the front No. 2 speaker assembly, make sure that the wire harness does not get caught between the front No. 2 speaker assembly and instrument panel.

      Tech Tips

      
      

      • Tighten the screws in the order shown in the illustration.

      • Use the same procedure for the RH and LH sides.

      • The procedure listed above is for the LH side.

4. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

   Click here

5. INSTALL FRONT PILLAR GARNISH

   Click here

6. INSTALL FRONT DOOR OPENING TRIM COVER

   Click here

7. INSTALL FRONT DOOR SCUFF PLATE

   Click here