STEREO COMPONENT AMPLIFIER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the stereo component amplifier assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Correct the steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER RH

    Click here

  4. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET


    1. Disconnect the connectors.

    2. Remove the 3 nuts and stereo component amplifier assembly with bracket.

      B002DPRC01
      *A w/ Mark Levinson Speaker System *B w/o Mark Levinson Speaker System

  5. REMOVE NO. 1 AMPLIFIER BRACKET


    1. B002EK4C02
      *A w/o Mark Levinson Speaker System
      *B w/ Mark Levinson Speaker System

      Remove the 2 screws and No. 1 amplifier bracket.

  6. REMOVE NO. 2 AMPLIFIER BRACKET


    1. B002DN6C02
      *A w/o Mark Levinson Speaker System
      *B w/ Mark Levinson Speaker System

      Remove the 2 screws and No. 2 amplifier bracket.