AMPLIFIER ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 1 amplifier antenna assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Correct the steering angle neutral point Parking assist monitor system

Click here

LKA / LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE ROOF HEADLINING

    Click here

  2. REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY


    1. B002DB7

      Disconnect the 2 connectors.

    2. Disengage the clamps.

    3. Remove the 2 nuts and No. 1 amplifier antenna assembly.