STEERING LINKAGE INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL POWER STEERING LINK ASSEMBLY

   
   

   1. Install the power steering link assembly with the 2 bolts, 2 washers and 2 nuts.

      Torque:

      117.6 N*m  { 1199 kgf*cm, 87 ft.*lbf }

   2. 

      Connect the 2 wire harness clamps to the power steering link assembly.

   3. Connect the 3 wire harness connectors to the power steering link assembly.

      Tech Tips

      When connecting the connector with lock lever, return the lock lever to its original position and securely push in the lock of the lock lever as shown in the illustration.

2. CONNECT TIE ROD ASSEMBLY LH

   
   

   1. Connect the tie rod assembly LH to the steering knuckle with the nut.

      Torque:

      65 N*m  { 663 kgf*cm, 48 ft.*lbf }

      Note

      Prevent oil from adhering to the threaded and tapered parts.

   2. Install a new clip.

3. CONNECT TIE ROD ASSEMBLY RH

   Tech Tips

   Perform the same procedure as for the LH side.

4. INSTALL STEERING SLIDING YOKE WITH SHAFT SUB-ASSEMBLY

   
   

   1. 

      *a

      Matchmark

      Align the matchmarks on the steering sliding yoke with shaft sub-assembly with the matchmarks on the power steering link assembly.

   2. 

      Install the bolt (B) and tighten the bolt (A).

      Torque:

      35.3 N*m  { 360 kgf*cm, 26 ft.*lbf }

5. INSTALL FRONT LOWER SUSPENSION MEMBER PROTECTOR

   Click here

6. INSTALL NO. 2 FRAME CROSSMEMBER ASSEMBLY

   Click here

7. INSTALL NO. 1 FRAME CROSSMEMBER ASSEMBLY

   Click here

8. INSTALL NO. 1 OIL COOLER BRACKET

   Click here

9. INSTALL OIL COOLER BRACKET

   Click here

10. INSTALL FRONT FENDER LINER LH

    Click here

11. INSTALL FRONT FENDER LINER RH

    Click here

12. INSTALL FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY

    Click here

13. INSTALL REAR ENGINE UNDER COVER LH

    Click here

14. INSTALL REAR ENGINE UNDER COVER RH

    Tech Tips

    Perform the same procedure as for the LH side.

15. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

16. INSTALL FRONT WHEELS

    Click here

17. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

19. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

20. ROTATION ANGLE SENSOR INITIALIZATION AND TORQUE SENSOR ZERO POINT CALIBRATION

    Click here