HEATED STEERING WHEEL CONTROLLER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel heater control assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

    Click here

  2. REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY


    1. B002EW2

      Disengage the 4 claws of the lower steering wheel boss cover.

      Tech Tips

      Do not remove the lower steering wheel boss cover from the steering wheel sub-assembly. Loosen the lower steering boss cover.

    2. B002DTU

      Disconnect the connector.

    3. B002E6O

      Disengage the clamp.

    4. Remove the 2 screws and steering wheel heater control assembly from the lower steering wheel boss cover.