STEERING COLUMN ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT TILT STEERING GEAR WITH MOTOR ASSEMBLY


    1. A01QB2PC01
      *a Capsule

      Check that the 2 capsules are securely installed to the tilt steering gear with motor assembly as shown in the illustration.

      If the capsules are deformed, damaged or misaligned, replace the tilt steering gear with motor assembly with a new one.

  2. INSPECT TILT MOTOR


    1. B002CSLC47
      *a

      Component without harness connected

      (Tilt Motor)

      Apply 12 V battery voltage to the tilt motor connector. Then check the steering wheel tilt operation.

      OK
      Measurement Condition Specified Condition

      • 12 V battery positive (+) lead → Terminal 2 (TIM-)

      • 12 V battery negative (-) lead → Terminal 1 (TIM+)

      		 The steering wheel tilts down.

      • 12 V battery positive (+) lead → Terminal 1 (TIM+)

      • 12 V battery negative (-) lead → Terminal 2 (TIM-)

      		 The steering wheel tilts up.

  3. INSPECT TELESCOPIC MOTOR

    A01QAQEC48
    *a

    Component without harness connected

    (Telescopic Motor)

    1. Apply 12 V battery voltage to the telescopic motor connector. Then check the steering column telescopic operation.

      OK
      Measurement Condition Specified Condition

      • 12 V battery positive (+) lead → Terminal 2 (TEM+)

      • 12 V battery negative (-) lead → Terminal 1 (TEM-)

      		 The steering column contracts.

      • 12 V battery positive (+) lead → Terminal 1 (TEM-)

      • 12 V battery negative (-) lead → Terminal 2 (TEM+)

      		 The steering column extends.