PARKING BRAKE ASSEMBLY DISASSEMBLY

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

  • Rear disc

  • Parking brake shoe

Tech Tips

Replaced or removed and installed

 Parking brake bedding Electric parking brake system

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

    Click here

  4. REMOVE REAR DISC

    Click here

  5. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Rear Side)


    1. A01Q938N01

      Using SST, remove the parking brake shoe return tension spring.

      SST
      09703-30011

  6. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Front Side)


    1. A01QAT9N01

      Using SST, remove the parking brake shoe return tension spring.

      SST
      09703-30011

  7. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET


    1. A01QATX

      Slide the parking brake shoe and remove the parking brake shoe adjusting screw set.

  8. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY


    1. A01QCMHN01

      Using SST, remove the parking brake shoe hold down spring cup, parking brake shoe hold down compression spring and parking brake shoe hold down spring pin.

      SST
      09718-00011

    2. Remove the No. 2 parking brake shoe assembly.

  9. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY


    1. A01QD3UN01

      Using SST, remove the parking brake shoe hold down spring cup, parking brake shoe hold down compression spring and parking brake shoe hold down spring pin.

      SST
      09718-00011

    2. Remove the No. 1 parking brake shoe assembly.

  10. REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY


    1. A01QBXY

      Slide the parking brake shoe lever sub-assembly.

    2. A01QAJH

      Separate the No. 3 parking brake cable assembly to remove the parking brake shoe lever sub-assembly.

  11. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. A01Q969

      Remove the nut and separate the No. 3 parking brake cable assembly.

  12. REMOVE PARKING BRAKE ANCHOR BLOCK SUB-ASSEMBLY


    1. Remove the rear axle hub and bearing assembly.

      Click here

    2. A01QBL6

      Remove the 2 nuts, cable support bracket and parking brake anchor block sub-assembly.