FRONT BRAKE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT DISC


    1. B002CUM

      Check the identification mark to determine the installation side.

      Note

      The front disc needs to be installed to the correct side of the vehicle. There is a "LEFT", indicating the disc for the left wheel, or a "RIGHT", indicating the disc for the right wheel, engraved on the disc in the position shown in the illustration.

    2. When reusing the front disc:


      1. B002D89C01
        *a Matchmark

        Align the matchmarks of the front disc and front axle hub sub-assembly, and install the front disc.

    3. When replacing the front disc:


      1. Inspect the front disc runout.

        Click here

      2. Select the installation position where the front disc has minimal runout, and install the front disc.

    4. Temporarily install the hub nut.

  2. INSTALL DISC BRAKE CYLINDER ASSEMBLY


    1. Install the disc brake cylinder assembly to the steering knuckle with the 2 bolts.

      Torque:
      135 N*m  { 1377 kgf*cm, 100 ft.*lbf }

  3. CONNECT FRONT FLEXIBLE HOSE


    1. Connect the front flexible hose to the disc brake cylinder assembly with a new union bolt and a new gasket.

      Torque:
      39.2 N*m  { 400 kgf*cm, 29 ft.*lbf }

      Note

      Install the front flexible hose lock securely into the lock hole in the disc brake cylinder assembly.

  4. INSTALL FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT

    Click here

  5. INSTALL FRONT DISC BRAKE PAD

    Click here

  6. BLEED BRAKE LINE

    Click here

  7. INSTALL FRONT WHEEL

    Click here